Problem: When I connect the Carprog and go to open project and to project folder and pick the flash file sample in the profile folder, it connect alright but when I try to get the flash file for 4.74 cp, when I try to connect I get that error... but even though saved in .flash but it connect the dump file I have for the cp , but it connect the dump sample file that is in the project folder that is installed by the jlink, but when I try to connect dump file for cp, it give error. Solution: Carprog reprogramming using JLink Step by step as follows: 1. You need to clear mcu, operate by following this video tutorial. 55 pin in programming is now here connected, Connect to JLink: Carprog connect to 12V. I reprogrammed the MCU as shown in this video: after reprogramming Mcu, pin 55 connect to Gnd Product link:http://www.eobd2.fr/carprog-v531-carprog-full-3300.html
0 Comments
Leave a Reply. |